Wall Column Formwork
Adjustable SBPL Circular Formwork
Wall Column Formwork
Adjustable SBPL Circular Formwork
The circular formwork is a practical system for forming of smooth and curved walls. Infinitely adjustable for diameters from 8 meters to infinite.
The required radius is easily achieved by using adjustable turn-buckle. Panel size are as follows: 100 cm, 120 cm in width and 100 cm, 120 cm and 150 cm in height. MS sheet has 4 mm thickness.
-
60 kN/m2 permitted pressure of fresh concrete
-
High quality MS shuttering is used
-
The system elements are pre-assembled and are ready for use simply by setting the desired radius with the adjusting spindles.
-
Installation of pre-assembled units minimizes use of crane.
-
Smaller quantities are needed, as it adapts effortlessly to any layout.
-
High durability resulting in lower the expense.
-
Low cleaning cost and restoration.
-
High quality of concrete surface minimize finishing work.
-
Having only 6 standard panel provides much easier planning and forming.
-
All the connectors and accessories are easily fixed into the slots and quickly tighten, consequently forming time is efficient and maximized.
-
Plywood is not in use hence longer durability as well as save time in changing plywood from time to time and again setting up
-
Radii can be continuously adjusted from a diameter of 8 m upward, simply by turning buckles.
-
Accessories such as — bracing platforms, bracing struts etc., make for save and easier handling of the system.
-
Radii are set easily—simply by turning buckles.
-
There is only one type connection device (Adjustable clamp).
